Español

Basic ECG Course. Lesson 17. Second-Degree AV Block

Block 2 · Cardiac conduction · 20 min of reading and practice

There’s a P wave right where you expected it. Then the line carries on and its QRS is missing. To know what kind of block you’re looking at, you’ll also need to read the beats that did get through.

Confirm the PP and measure the PR intervals before and after the P wave left without a QRS.

By the end of this lesson you should be able to

  • Recognize a sinus P wave on time that isn’t conducted.
  • Tell the typical Wenckebach pattern from the Mobitz II pattern.
  • Report a 2:1 AV block without automatically assigning it a subtype.
  • Recognize high-grade block when two or more consecutive P waves don’t conduct and some conduction remains.

1. Before you classify the block

Find the P waves, check their morphology and follow their PP intervals, even through the gap between QRS complexes. The wave you’re looking for has to belong to the underlying atrial rhythm. If the P wave comes early and distorts the T wave, go back to the differential from the lesson on pauses.

Number the P waves. Mark which ones conduct, measure the PR of those that have a QRS and compare both sides of the gap. If the recording is short or noise makes the sequence hard to identify, write down the limitation.

2. Mobitz I, or Wenckebach

In the classic example, the PR lengthens over successive beats until a P wave on time is left without a QRS. The first conducted PR after the gap is shorter again than the last PR before the pause. The sequence can repeat and group the QRS complexes together.

Picture three successive PR intervals of 160, 230 and 310 ms, followed by a P wave with no QRS and a new PR of 160 ms. You’ve just found the lengthening and the reset in the same cycle. Real tracings include less regular sequences. It’s worth comparing several groups before deciding.

3. Mobitz II

The sinus P waves keep their rhythm. A P wave that arrives on time is left without a QRS, and the PR intervals of the conducted beats right before and after it stay the same. To use this label, the strip needs to show enough consecutive conduction and a stable PP, and the finding mustn’t be explained by an early P wave or a simultaneous slowing of the sinus rate.

A wide QRS may come with this pattern. A narrow QRS can be seen too. The width tells you about intraventricular conduction and helps you weigh the context, while the PP–PR sequence establishes the teaching pattern.

4. 2:1 conduction and high-grade block

2:1 conduction. One P wave conducts and the next has no QRS. You only have one conducted PR per group and can’t see a progressive change within that group. Report “second-degree AV block with 2:1 conduction” and both rates. An additional stretch with a different conduction pattern may clarify the subtype.

High-grade block. Two or more consecutive P waves don’t conduct, yet there’s still evidence that some impulses reach the ventricles. In an example with a 3:1 relationship, you see two blocked P waves for every conducted one. How this differs from complete block is covered in the next lesson.

5. What to report

In step 2, note the rate and regularity of the atria and the ventricles. In step 4, describe the P–QRS pattern and what the PR intervals do. In step 5, add the QRS width. In the integration, include the pattern, the stretch you examined and the limitations.

A possible Mobitz II or high-grade block is clinically relevant even if the person is conscious at the time. Bradycardia with syncope or signs of hypoperfusion needs immediate clinical assessment.

PatternBehavior you can demonstrate
Typical WenckebachThe PR lengthens before the P wave that fails and shortens after the gap.
Typical Mobitz IIStable PP and equal PR intervals before and after a single sinus P wave that doesn’t conduct.
2:1Alternating conducted and blocked P waves. The sequence on its own doesn’t allow subtyping.
High-gradeAt least two consecutive P waves with no QRS, with evidence of AV conduction in other beats.

6. Practice

Look at the ECG before opening the solution. You can zoom in on the tracing to count boxes.

Tracing A

12-lead ECG A with groups of complexes for measuring successive PR intervals.
Tracing A. Measure the PR intervals between two gaps on the lead II strip. Open the ECG at full size
  1. How many P waves conduct per group? How do their PR intervals change?
  2. Compare the last PR before the gap with the first one after it.
See the worked solution

Groups of three conducted P waves repeat. The PR goes from about 160 ms to about 230 ms and then to about 310 ms. Look for roughly 4, 6 and 8 small boxes. In lead II, the third P wave starts near the end of the preceding T wave, so its onset is less crisp. The fourth P wave sits on the downslope of the T wave of the third QRS and doesn’t conduct. Extend the rhythm of the P waves to recognize it. The PR goes back to about 160 ms as the next group starts. It’s Wenckebach, with 4:3 conduction.

Tracing B

12-lead ECG B. Compare the atrial rhythm with the PR of the conducted complexes.
Tracing B. Check the PP and the PR intervals around each gap. Open the ECG at full size
  1. Project the PP across the gap. How many expected P waves in a row are left without a QRS?
  2. What changes in the PR before and after each gap?
See the worked solution

The PP stays stable, close to 0.65 s. On the long lead II strip, the third P wave is the first one that doesn’t conduct. It shows up at the end of the T wave of the second QRS and lands where the earlier PP intervals predict. In the conducted cycles around the gap, the PR is about 200 ms. There are two consecutive conducted P waves per group, with a single repeated failure. Taken together, this fits Mobitz II with a narrow QRS.

Tracing C

12-lead ECG C with a long strip for comparing the two rates.
Tracing C. Count the P waves for each ventricular cycle. Open the ECG at full size
  1. Calculate the rate from the PP and from the RR. What relationship do you see?
  2. How many consecutive conducted PR intervals can you compare within each group?
See the worked solution

The P waves run at about 72 bpm and the QRS complexes at about 36 bpm. A conducted P wave alternates with a blocked one. The pattern is reported as 2:1 AV block. The subtype stays open with this fragment.

Tracing D

12-lead ECG D with a long strip and several P waves between QRS complexes.
Tracing D. Check whether any P wave keeps a repeatable relationship with a QRS. Open the ECG at full size
  1. Count how many P waves in a row are left without a QRS.
  2. What happens with the next P wave, and what relationship does it keep in other groups?
See the worked solution

The PP intervals are about 0.83 s (72 bpm) and the RR intervals 2.50 s (24 bpm). Two consecutive P waves are left without a QRS and the third conducts with a repeatable PR close to 200 ms. In this example it’s high-grade AV block with 3:1 conduction.

7. Check what you’ve learned

1. PR intervals of 160, 230 and 310 ms, one blocked P wave and a new PR of 160 ms. What pattern is this?
2. With several consecutive conducted P waves, a single sinus P wave on time with no QRS, a stable PP and equal PR intervals before and after, which pattern fits?
3. One P wave conducts, the next is blocked and the pattern repeats. What can you report?
4. Two P waves in a row don’t conduct and the third conducts with a repeatable PR. How do you describe it?
5. Which finding means you should rethink a Mobitz II hypothesis before closing the reading?

8. Summary

  • Show that the nonconducted P wave arrives on time.
  • The PR intervals before and after the gap tell the typical Wenckebach and Mobitz II patterns apart.
  • Describe 2:1 as 2:1. In high-grade block, at least two consecutive P waves are blocked and some AV conduction remains.

In Lesson 18 we’ll see what happens when the atria and the ventricles keep their own separate rhythms.


Video for this lesson

Coming soon. The video lesson will be published on YouTube (in Spanish) and embedded here.