Basic ECG Course. Lesson 16. First-Degree AV Block
Block 2 · Cardiac conduction · 12 min of reading and practice
Every P wave has its QRS. At first glance the rhythm looks orderly, but there’s more distance than usual between the start of the two waves. How long does the impulse take to reach the ventricles?
A 1:1 relationship and a PR over 200 ms in adults.
By the end of this lesson you should be able to
- Measure the PR from the start of the P wave to the first deflection of the QRS.
- Show that every P wave conducts in the complete cycles.
- Recognize the typical pattern and describe it together with the rhythm and the QRS.
- Explain how far the surface ECG lets you locate the delay.
1. Measure the whole interval
It doesn’t matter whether the QRS starts with a negative Q wave or a positive R wave. The PR starts at the first deflection of the P wave and ends where the QRS begins. The stretch between the end of the P wave and the start of the QRS is only the PR segment.
Use a lead where the start of the P wave is clear, and double-check the measurement where the start of the QRS is easiest to see. On a simultaneous multichannel recording, the earliest onset may show up better in another lead. Repeat over more than one cycle and confirm the paper speed.
At 25 mm/s, five small boxes equal 200 ms. Six equal 240 ms. At 50 mm/s, each small box lasts 20 ms, and the same measurement would take up twelve boxes.
2. What “first-degree” means
The basic adult criterion is a 1:1 P–QRS relationship with a PR longer than 200 ms. In the typical example, the PR is stable and the QRS stays the same distance from each P wave. Exactly 200 ms sits at the upper limit of the reference used in this course.
The term describes a conduction delay. To prove it, go through the strip looking for every P wave, including any that might be sitting on a T wave. A P wave on time with no ventricular response changes the problem and takes us to second-degree block, if other impulses do conduct.
3. The PR is a total time
Between the start of the P wave and the start of the QRS come atrial activation and conduction toward the ventricles. The AV node usually accounts for much of that time, but the atria and the His–Purkinje system contribute too.
A narrow QRS describes ventricular activation once it has started. A wide QRS can coexist with a prolonged PR. Record both findings and avoid assigning the PR an anatomical location that the strip alone doesn’t prove.
4. Write a measurable conclusion
“Sinus rhythm at 65 bpm, 1:1 conduction, constant PR of 240 ms and narrow QRS.” That sentence lays out the data that support your interpretation. A previous recording helps you know whether the PR was already like that.
If the PR is very long, the P wave may end up closer to the preceding T wave than to the QRS it belongs to. Work on a long strip. Check which pairing repeats while the atrial rhythm stays steady.
5. Practice
Look at the ECG before opening the solution. You can zoom in on the tracing to count boxes.

- Measure the PR in two or three clean cycles in lead II.
- Follow every P wave. Do you find a well-defined one with no QRS after it?
- Measure or estimate the QRS width. Write the conclusion.
See the worked solution
On the long lead II strip, the PR takes up about six small boxes, roughly 240 ms at 25 mm/s. Mark the start of the P wave and the start of the QRS. The peak of the R wave comes a little later. The PR stays similar from cycle to cycle and there’s 1:1 conduction over the readable stretch. The QRS is narrow and the rate is around 65 bpm.
Integration. Sinus rhythm with first-degree AV block and a narrow QRS.
6. Check what you’ve learned
The PR includes the whole P wave and ends where ventricular activation begins.
Six boxes of 40 ms equal 240 ms, above 200 ms.
In first-degree block every P wave conducts. The finding is the delay.
The PR measures the total time until the QRS begins. Its duration on its own doesn’t identify the segment responsible.
7. Summary
- Measure from the start of the P wave to the start of the QRS.
- In adults, a PR over 200 ms with 1:1 conduction defines the first-degree pattern.
- Describe the PR and the QRS separately before putting them together.
In the next lesson we’ll follow the P waves that end up with no QRS, and what the PR does before and after them.
Video for this lesson
Coming soon. The video lesson will be published on YouTube (in Spanish) and embedded here.
