Basic ECG Course. Lesson 11. ST Segment and T Wave
Seeing ST elevation is striking. But “ST elevation” describes what we see; “infarction” tries to explain why we see it. There are several steps between those two phrases, and we shouldn’t skip them.
Describe first. Then put it together.
In this lesson we’ll learn to analyze ST and T in an orderly way, without getting into the diagnostic criteria for ischemia, pericarditis, electrolyte disorders or other clinical patterns yet. Those come in their own blocks.
By the end of this lesson you should be able to
- Explain why ST and T should be interpreted after the QRS.
- Find the J point.
- Choose a reasonable baseline.
- Describe the ST segment by position, shape and distribution.
- Understand why contiguous leads matter.
- Describe the T wave by polarity and morphology.
- Recognize the basic variability of the normal T wave.
- Recognize that an abnormal QRS can come with secondary repolarization changes, without needing to classify all those patterns yet.
- Use a previous ECG to judge how things have changed.
1. Before the ST segment, look at the QRS
The method puts QRS and chest leads before ST and T because repolarization can’t be interpreted while ignoring how ventricular depolarization happened.
Before analyzing the ST segment, remember:
- was the QRS narrow or wide?
- did its morphology look usual or clearly altered?
- were there striking changes in ventricular activation?
An abnormal QRS can come with secondary changes in ST and T. We don’t need to diagnose the mechanism yet; we do need to remember that what repolarization means also depends on what happened before it.
2. The J point and the baseline
The ST segment starts at the J point, where the QRS ends and the ST segment begins.
To talk about elevation or depression we need a reference. When it’s clearly visible, the TP segment, between the end of the T wave and the start of the next P wave, is an especially useful reference.
In tachycardias or difficult tracings the TP segment may be hard to make out. In that case other references have to be used with caution. What matters is not measuring against an imaginary line.
Before you say “up” or “down”, decide where the QRS ends and what your baseline is.
Also, a normal ST segment doesn’t have to be mathematically flat. It can vary slightly depending on the lead and the patient.

3. Don’t just ask whether the ST goes up or down
A useful reading of the ST segment needs several questions:
- Position: are the J point and the ST segment roughly at the reference, elevated or depressed?
- Shape: is the ST horizontal, upsloping, downsloping, concave, convex or some other shape?
- Distribution: which leads does it appear in?
- Contiguity: does it also appear in electrically neighboring leads?
- Relationship: how does it fit with the QRS, the T wave and previous ECGs?
With these questions we stop chasing a single millimeter and start recognizing a pattern.
4. Contiguous leads matter
The 12 leads view the heart from different points of view. A change that shows up in several electrically neighboring leads usually carries more weight than a small isolated variation.
At this point in the course you don’t need to memorize all the coronary territories yet. You do need to add one question:
Is there a consistent distribution, or am I chasing a lone finding?
Distribution turns a local shape into a pattern. Later we’ll learn to link those patterns to specific territories and diagnoses.
5. ST elevation or depression: describe before you diagnose
ST elevation means the J point and the ST segment sit above the reference in a lead. ST depression describes the opposite.
Those phrases don’t identify the cause on their own. The same description can show up in different situations.
“ST elevation” describes. “Infarction” interprets. To interpret, we need criteria, distribution, the relationship with the rest of the ECG and the clinical context.
6. How to look at the T wave
The T wave represents ventricular repolarization. Normally it’s smoother and more rounded than the QRS and is often asymmetric: the upstroke tends to be a little slower and the downstroke a little faster.
When a T wave catches your eye, describe it before explaining it:
- is it positive or negative?
- is it tall or small?
- is it rounded or very peaked?
- is it asymmetric or surprisingly symmetric?
- is it biphasic?
- which leads is it in?
- is it new compared with a previous ECG?
7. T-wave polarity: a reference, not a password
In many leads the T wave keeps the same overall polarity as the QRS. A mostly positive QRS usually comes with a positive T wave. It’s a useful reference, not an absolute law.
As a basic guide in adults:
- the T wave is usually positive in I, II and V3–V6;
- it’s usually negative in aVR;
- it can vary in III, aVL, aVF, V1 and, especially in young people, V2.
So an isolated negative T wave shouldn’t automatically become a diagnosis. Look at shape, distribution, the QRS, the context and how it compares over time.
Going further · optional. You don’t need to classify repolarization changes as primary or secondary right now. Keep the practical idea: an abnormal QRS can change ST and T, and that’s why the QRS is interpreted before repolarization.
8. Primary and secondary changes: the basic idea
Here are two concepts we’ll use later:
- Primary repolarization change: the problem mainly affects electrical recovery.
- Secondary change: ST and T change because the way the ventricles were activated changed first.
You don’t need to classify every pattern today. Keep the logical order: QRS first; then ST and T in relation to it.
9. A previous ECG changes the meaning
Two tracings can show an identical negative T wave and mean very different things if in one it has been there for years and in the other it appeared today.
When there’s a previous ECG:
- compare the QRS;
- compare the ST segment;
- compare the T wave;
- ask whether the change is new, stable or dynamic.
A single ECG is a snapshot. Serial recordings help you build the movie.
10. Don’t measure the ST segment in isolation
Size doesn’t replace shape or distribution. A small, consistent change across several neighboring leads can tell you more than an isolated variation.
Also, if the baseline wanders or there’s tremor or artifact, we can measure something that belongs to the noise very precisely. That’s why, even at step 6, you may need to go back to step 1 and check the technique.

11. The step 6 routine
- QRS: remember what it looked like.
- J point: find the end of the QRS.
- Baseline: choose a reliable reference.
- ST position: roughly isoelectric, elevated or depressed.
- Shape and distribution: describe the morphology and the leads involved.
- T wave: polarity, shape and relationship to the QRS.
- Time: compare with previous ECGs if there are any.
This routine may not give you a diagnosis yet, and that’s fine. The goal of the fundamentals is to learn a way of looking that lets you diagnose later without skipping information.
12. Practice
You see ST elevation in a single lead. Can you write “infarction” straight away?
Show solution
No. First describe position, shape, distribution and the relationship with the QRS and T wave, and assess the context.
Where does the ST segment start?
Show solution
At the J point, where the QRS ends.
Wide QRS with ST and T changes. Do you interpret repolarization as if the QRS were normal?
Show solution
No. Abnormal ventricular activation can produce secondary repolarization changes.
A negative T wave appears only in a lead where normal variability exists. Immediate diagnosis?
Show solution
No. We need to assess shape, distribution, the QRS, the context and any previous ECG.
13. Check what you’ve learned
The QRS shapes how repolarization is read.
The J point joins the end of the QRS to the start of the ST segment.
It describes a position; it doesn’t identify the cause on its own.
Distribution adds information that an isolated finding doesn’t.
There are also leads with more normal variability.
That’s why the method analyzes the QRS first.
Comparing over time is part of interpretation.
14. Summary
- Before ST and T, remember what the QRS looked like.
- The ST segment starts at the J point.
- You need a reliable baseline before talking about elevation or depression.
- Describe the position, shape and distribution of the ST segment.
- Contiguous leads help you recognize a pattern.
- “ST elevation” and “ST depression” are descriptions, not diagnoses.
- Describe the T wave by polarity, shape, distribution and change over time.
- An abnormal QRS can produce secondary repolarization changes.
- A previous ECG can change what a finding means.
Video for this lesson
Coming soon. The video lesson will be published on YouTube (in Spanish) and embedded here.
Course navigation
← Lesson 10. QRS: duration, Q waves and precordial progression · Back to the course · Lesson 12. The 8-step interpretation method →
