Basic ECG Course. Block 2 Self-Assessment · Cardiac Conduction
You’ve reached the end of the block. In front of you is a new ECG with no diagnosis. Start with the technique and follow the eight steps in order. Write down your measurements before opening the solutions.
In the second part you’ll find 15 questions covering the whole block. You can answer them even if you still have doubts about the ECG.
Part A · Analyze this ECG with the 8-step method

1. Technique
Check the speed, gain, calibration and quality. How long does one small box last horizontally?
See the reasoning
A 12-lead recording at 25 mm/s and 10 mm/mV, with a visible calibration signal and a stable baseline. One small box represents 40 ms. The long lead II strip lets you follow complete cycles.
2. Rate, regularity and origin
Measure several PP and RR intervals on the bottom strip. Are they regular? Check the P-wave polarity in II and aVR.
See the reasoning
The PP and RR intervals are about 0.91 s. The atrial and ventricular rates are roughly 66 bpm. The P waves are regular, positive in II and negative in aVR, consistent with a sinus origin.
3. Electrical axis
Classify the quadrant with I and aVF. Use II to tell whether the axis stays near the limit or is clearly deviated.
See the reasoning
I is mostly positive and aVF mostly negative. II is also mostly negative. The axis is deviated to the left. The category is enough to justify the finding. In aVL there’s a small q followed by an R. In II, III and aVF you can see a small r followed by an S.
4. P wave and PR interval
Do all the P waves in complete cycles conduct? Measure the PR in two cycles. What conclusion can you defend?
See the reasoning
Every P wave in a complete cycle keeps a 1:1 relationship with its QRS. The PR is stable at about 260 ms, around six and a half small boxes at 25 mm/s. There’s first-degree AV delay.
5. QRS and chest leads
Estimate the width. Compare the end of the QRS in V1 and V6 and relate it to the limb-lead morphology.
See the reasoning
In V1 or V6, the QRS takes up about three and a half small boxes, close to 140 ms. There’s a terminal R′ in V1/V2 and a broad terminal S wave in V6. That’s the right bundle branch component. The marked left axis, the initial q followed by an R in aVL and the inferior rS support the left anterior component.
6. ST segment and T wave
Compare ST–T in the right chest leads and in the lateral leads. How does the wide QRS affect your reading?
See the reasoning
In V1–V3 the T wave is negative after the positive terminal deflection. In V5–V6 the T wave is positive after the terminal S wave. In this example the pattern fits secondary repolarization changes. On a real ECG, reading ST–T also depends on the symptoms and on tracings to compare with.
7. QT and QTc
Which part of the QT gets longer when the QRS is wide? What should you keep in mind before interpreting the QTc?
See the reasoning
The QT includes the QRS. Longer depolarization adds to the measured QT. If repolarization needs assessing, it’s better to use a method suited to a wide QRS, such as looking at the JT/JTc depending on the context. For this exercise it’s enough to recognize that limitation.
8. Integration
Write one sentence with the rhythm, the rate, the PR and the two QRS components. What can you say about the PR and the remaining fascicle?
See the reasoning
Regular sinus rhythm at about 66 bpm with bifascicular block (right bundle branch and left anterior fascicle) and first-degree AV block.
The prolonged PR describes an AV delay with 1:1 conduction. Its duration alone doesn’t prove that the delay happens in the remaining fascicle.
Part B · Question set
Pick one option per question and press “Check answers”.
Sixty divided by 1.25 is 48. The atria are already slow and every P wave conducts.
Atrial activity continues. What you need to explain is why ventricular responses are missing.
The P wave is early and different. It arrives at a moment when it may not be conducted.
The sequence resumes at the expected point after two baseline cycles. In the typical pattern, that supports an exit block.
The timing delay identifies an escape. If the baseline QRS was narrow, the width and morphology point to a ventricular origin.
There’s 1:1 conduction with a PR over 200 ms.
PR lengthening followed by a block and a reset is characteristic of the typical Wenckebach pattern.
The P wave belongs to the baseline rhythm, and conduction fails with no change in the neighboring PR intervals and no atrial slowing.
There’s only one conducted beat per group. You’d need another stretch to see how consecutive PR intervals behave.
The sequence shows that some beats are still being conducted.
The two sequences are independent. The rate and the narrow QRS point to where the escape comes from.
Late right ventricular activation explains the terminal positivity in V1 and the lateral S wave.
The morphology in both areas supports delayed left ventricular activation.
The bundle branch pattern shows up in the chest and lateral leads. The limb leads supply the fascicular component.
The prolonged PR tells you about conduction time. On its own it doesn’t show which segment is slow.
How to read your score
- 13–15 correct. You can move on. Reread any explanation you couldn’t have justified yourself.
- 10–12 correct. Go back to the lessons behind the questions you missed and repeat those steps on the ECG.
- 0–9 correct. First review how to track the P waves and measure the PR. Then go back to the axis and the shape of the QRS.
Block 2 · Cardiac conduction complete
← Lesson 21. Fascicular and bifascicular blocks · Block 2 index
In the next block we’ll use the same reading to study rhythms and arrhythmias. You’ll start again from the technique, the rate and the activation sequence.
